User guidance

Arming Doors And Motion Sensors Before Leaving The Home

→ Press away button on the left side. (You must press hard and hold untill the red armed light comes on) leave within 45 seconds.

Arming Doors Only When Someone Is Staying In The Home

→ Press stay button on the left side.

Disarm System

→ Enter your 4 digit security code then press the off button (same as the #1 button) you must do this within 30 seconds of entering your home.

To Activate The Chime Feature

→ (Keypad will ding each time an exterior door is opened): enter your 4 digit security code then press the #9

How To Bypass A Zone

→ Type in master code – type 06 – type in the zone number you would like to bypass.

Your System Has 2 Panic Buttons That Are Always Active And Ready To Be Used Even If The System Is Not Armed

1. Fire button located on left side.
2. Police button located on left side.

Press And Hold The Desiered Button Until It Engages The Alarm, Central Station Will Notify The Authorties That You Are Home And Need Help

To Change Master Code Or Enter New Codes For Other Users (Cleaners, Pet Sitters, Contractors, Etc.)

  • Master code change: Enter current master code – press 8 – press 02 – enter new 4 digit master code – enter new master code again. Keypad will beep 1 or 3 times if code was accepted.

  • User codes 04 – 12: Enter master code – press 8 – press 04 (or next user number if 04 has a code assigned) – enter new code. Keypad will beep once if code was accepted. Test by using code and arm stay, then user code to disarm. (do not use the quick arm buttons to test).

  • Remove a code:Enter master code – press 8 – press useer number (04 – 12) – press #0 – wait 5 seconds keypad will beep once confirming code has been removed.

  • Trouble condition: Call first alarm llc 800-339-6468 for technical help and/or service.